[MSNoise] compute mwcs error

[Michelle Lee]

Hi,

Thanks. I think that might be it. My filter is fairly narrow, so that might
be why. Thanks again!

Best Wishes,
Michelle Lee

On Wed, Nov 24, 2021, 2:52 AM Thomas Lecocq <Thomas.Lecocq at seismology.be>
wrote:

> Hi,
>
> This usually means that no points for computing the linear regression.
> Did you set up a very very narrow filter, narrower than the number of
> points available in the spectrum ?
>
> Thomas
>
> Le 23/11/2021 à 14:49, Michelle Lee a écrit :
> > Hello everyone!
> >
> > Hope everyone is doing well! I ran into an error while trying to run
> > compute_mwcs. I am not quite sure what the error fully means and was
> > wondering if anyone could help me with the error or point me in the right
> > direction to troubleshoot and resolve the error. Thanks!
> > [image: Screen Shot 2021-11-23 at 8.43.25 AM.png]
> > Best Wishes,
> > Michelle Lee
> >
> ----------------------------------------------------------------------------
> > Ph.D. Candidate
> > Columbia University: Lamont-Doherty Earth Observatory
> > Department of Earth and Environmental Science
> > Marine Geology and Geophysics
> > c: (206)397-2488
> > alt. email: mkl2158 at columbia.edu
> >
> >
> > _______________________________________________
> > MSNoise mailing list
> > MSNoise at mailman-as.oma.be
> > http://mailman-as.oma.be/mailman/listinfo/msnoise
> _______________________________________________
> MSNoise mailing list
> MSNoise at mailman-as.oma.be
> http://mailman-as.oma.be/mailman/listinfo/msnoise
>